So I have to re-fabricate F-710B which is made from 6061-T6 .125x1x1 angle that the horizontal stab attaches to. I ordered the new angle from Aircraft Spruce, and the invoice says it's 6061-T6...but there is nothing stamped on the angle itself.
Obviously being a very critical piece, I am stressing about whether or not it is the correct type. Is there a way to determine this, or should I order another piece from Van's instead?
Obviously being a very critical piece, I am stressing about whether or not it is the correct type. Is there a way to determine this, or should I order another piece from Van's instead?