[lwfussell]

Does anyone know of a source for Stainless Steel Countersunk Flush Tinnerman (finish) Washers the part Number I believe is NAS1169-4C. For the past week I have searched the normal Aircraft sites and a number of fastener sites including Tinnerman. Only needing a box of 100 has generated zero response from the Fastener guys and Air Craft Spruce no longer carries them. Any help in locating a source would be greatly appreciated. As an alternative if I could find a thin say .010-.012 SS washer about 1/2inch in diameter with a #4 hole I could try to dimple them with a squeezer.

I am using #4 countersunk screws to attach the wingtips and don?t like what it does to the paint. Any other alternatives would also be appreciated.

Larry
7-A
Final assembly

 

[pdecraene7a]

Try Micro Fastners
http://www.microfasteners.com/

 

[rvpilot]

Washers!

Larry-
Try this link-
http://www.airsuppliers.com/aircraftparts/HARDWARE.asp
Good Luck!

 

[William Slaughter]

No countersunk washers listed on the Microfasteners web site.

 

[Bryan Wood]

Tinnerman washers

Try this.

http://www.aircraftspruce.com/menus/ha/washers.html

Best,

 

[William Slaughter]

Aircraft Spruce link shows only #6, #8, and #10, no #4.

 

[GAHco]

25,000 on order.

Go to http://www.gen-aircraft-hardware.co...rge+Area -> Washers&menuID=237~238~238&id=243

New Item at popular request. Expected to be in house mid to late April 2007

Sorry Not in our Ref Book yet.

Specs for Stainless 100 degree, countersunk, large area washer for #4 screw,

OD= .375
ID= .116
Thickness .010 to .012
Material 304 shiny

To see the tech page for our other Specialty Washers go to.

http://www.gen-aircraft-hardware.com/images/pdf/specialwash.pdf