Inspired by my kids' aforementioned aquisition of a 3D printer, a few commercial aoa vanes like belite, two days of watching YouTube videos on how to use Fusion 360, and a lot of stubbornness, I created this:
I bought a couple little Hall effect sensors and magnets (which I have not successfully used yet) and a couple tiny little rotary encoder doohickeys.
This version will use the rotary encoder.
I'm not sure when I'll get to play with it more, but I'm hoping to eventually couple to an OnSpeed tone system like the super smart guys on here have been developing and working on.
I was pretty excited with how it turned out visually, we will see where it goes.
I bought a couple little Hall effect sensors and magnets (which I have not successfully used yet) and a couple tiny little rotary encoder doohickeys.
This version will use the rotary encoder.
I'm not sure when I'll get to play with it more, but I'm hoping to eventually couple to an OnSpeed tone system like the super smart guys on here have been developing and working on.
I was pretty excited with how it turned out visually, we will see where it goes.
Last edited: