[skydiverlv]

Did I once read on a blog or here that the lp4-3 rivets that attatch the seat floors to the bulkhead need the manufactured head inside the bulkhead for
landing gear clearance? I have searched but unable to find anything about it.

 

[Mich48041]

21-02 step 4

Did I once read on a blog or here that the lp4-3 rivets that attatch the seat floors to the bulkhead need the manufactured head inside the bulkhead

skydiverlv,
If you are on page 21-08, then you are past that point in the plans. See 21-02 step 4 and the links below
Joe
http://www.vansairforce.com/community/showpost.php?p=313618&postcount=1

http://www.vansairforce.com/community/showthread.php?t=66210

 

[skydiverlv]

Thanks Joe! The second link you posted indicated that the 4th cs4-4 and the
5th lp4-3 of the seat floor interfere with the landing gear installation. I will leave those out until the gear is in place.