MacPara
Well Known Member
Finally I have run into a problem that I can't seem to figure out by myself. I've also searched blogs of fellow builders and it appears that no-one else had a problem with this before, so you guys are my last hope before calling Van's.
On page 10-04 in step 2 it says to flute the bulkhead F-1211A slightly to remove the pucker in 4 places. Well, it appears that what creates the pucker looks like a slight flute to me (see photo). Now, how am I supposed to eliminate something that looks like a flute with another flute? Shouldn't I use seamers instead to flatten it? How did you solve this problem?
Thanks,
Torsten.
On page 10-04 in step 2 it says to flute the bulkhead F-1211A slightly to remove the pucker in 4 places. Well, it appears that what creates the pucker looks like a slight flute to me (see photo). Now, how am I supposed to eliminate something that looks like a flute with another flute? Shouldn't I use seamers instead to flatten it? How did you solve this problem?
Thanks,
Torsten.
![F1211A.jpg](/community/proxy.php?image=http%3A%2F%2Fdl1fy.dyndns.org%2Fpics%2FF1211A.jpg&hash=281496aaf9be49e37d7c3d9a87a7dff4)