Tip tip
Here's a tip forum tip for Noobs (like me). Read every thread in the Tip Forum before touching a single piece of aluminum or a single rivet. I wish I had. I learned so much in just a little time.
Once you've read all the tips, find a mentor or take a course.
Practice on scrap. Rivet then drill them out and do it again till the confidence is there.
I learned a ton. Rivets are looking better. Time to start the tail feathers!
__________________
Larry Larson
Estes Park, CO
http://wirejockrv7a.blogspot.com
wirejock at yahoo dot com
Donated 12/03/2019, plus a little extra.
RV-7A #73391, N511RV reserved (2,000+ hours)
HS SB, empennage, tanks, wings, fuse, working finishing kit
Disclaimer
I cannot be, nor will I be, held responsible if you try to do the same things I do and it does not work and/or causes you loss, injury, or even death in the process.
|
Linear Mode
