prop Governor

[garymail]

My prop began to hunt a bit after 650 hours. did a little research, found that MT began using a different type of governor about 5 years ago, manufactured by AVIAN in Checkoslovakia, looks similar to other Check manufactures, but is different inside. The Avian begins with a -8__, others in the past use a -9__ series. Anybody else having prop hunting problems?
Also, if needed, I can issue certificates of airworthiness in the Northwest US as well as condition inspections, pre buy, ferry, and transition training.

Regards,
Gary gdbrown@minetfiber.com

[mannanj]

Call the MT folks in Florida. There might be a recall on that. I know that they repaired mine in 2007 for that reason, but I think it was still under warrantee.
Won't hurt to get in touch with them, they might give you a break on price since that was a known problem with those govenors during that period.

[kiwipete]

Hi

There is quite a bit about these governors if you do a search. Basically any of these mt governors that have a serial letter ending in a letter less than -F need to be sent back to be modified.

See thread below.

http://www.vansairforce.com/communit...ighlight=surge

MT know about the problem and historically looked after there customers.

Peter

[garymail]

MT wont do anything but charge $800 for OH, or give $200 for core. I elected core.

Gary

[erich weaver]

Yeah, mine surges a bit on occasion but only when at max rpm. I just dial it back slightly and I'm good. Not sure what state you are in, but I think Ameritech Industries in Redding, CA can fix it if that's close to you at all.

erich