I'm in the San Marcos, TX area today and tomorrow, and would very much like to look at someones 7 or 9 slider finished canopy setup to get a few pointers as to final fit and finish. I'm in the middle of this particular piece right now and just putting eyeballs on a finished version would clear up a lot of questions that are still left open from the instructions and drawings.
Of course, if the weather clears, I'll pop for a tank of fuel in exchange for 30 minutes of stick time too...
__________________
Greg Niehues - SEL, IFR, Repairman Cert.
Garden City, TX
VAF 2020 dues paid 
N16GN flying 700 hrs and counting; IO360, SDS, WWRV200, Dynon HDX, 430W
Built an off-plan RV9A with too much fuel and too much HP. Should drop dead any minute now.
San Antonio/Austin sliders to look at?
Linear Mode
