TMXIO-360 numbers

[HSANTIBANEZ]

Hi, Im in the final configurating process of the G3X System, so i need some help with the folowing numbers:

OIL Temp red low limit, yellow low range, green normal range, yellow up range, red up limit.

Same for Oil Press, and Fuel Press.

Thak you in advanced,

Regards,

[Bruce]

Hernan,

Numbers will be in your engine manual.

[Rick_A]

Actually, I found it quite a bit of working figuring out the all the ranges when I configured my MVP-50. Listed below are the numbers I used but I think I've tweaked them a bit since I wrote them down. At least this will be a starting point for you.

EGT: R: 1650 & above; Y:1401 - 1649; G: 1200 - 1400 Y: below 1200
CHT: R: 400 & above during break-in, then 460 & above; Y: 401 - 459,
G: 212 - 400; Y : below 212
Fuel Flow G: 5.8 - 14.8; R: 14.9 & above
Fuel Press (Carb) R: 8.1 & above; G: 2.0 - 8.0; Y:0.5 - 1.9; R: 0.4 & below
Oil Pressure: R: 96 & above; Y: 81 - 95; G: 60 - 80; Y: 20 - 59; R: Below 20
Oil Temp: R: 240 & above; Y: 201 - 239; G: 130 - 200; Y: 75 - 129 R: below 75


Now that I've written this reply, I think I may need to go review all my setting to verify whether or not these numbers reflect the current state of my settings. I think I'll change Oil Pressure to be: Green 60 - 90 ... and I'm open to suggestions from any of the experts.

[HSANTIBANEZ]

Thank you Rick!