EXP2Bus setup for external master relay
I'm troubleshooting a starting problem with my EXP2 Bus using an external master relay setup. For those using it, can you reply with your setup
I think this may be the proper setup.
Can anyone verify this is correct? Or help with the setup.
From EXP2 Bus
ALT to Alternator output
BAT to Battery+
BAT to Master Relay "B" terminal
Square K1 pads jumped together with a #12 wire
P10 to the center lug of the master relay
J16 connected to J10
__________________
Danny "RoadRunner" Landry
Morphed RV7(formally 7A), N20DL, PnP Pilot
1190+ hours
2019 Donation Paid
Last edited by roadrunner20 : 06-04-2006 at 08:37 PM.
|
Linear Mode
