Governor Cover

[boom3]

I'm running a Sensenich fixed pitch prop.

Aerosport sent me this cover and said with it and the prop line installed, I do not need to puncture the rear crank plug. I do need to plug the front of the crank.

My question is should I trim the gasket a little around this opening.

It would make sense to me, but thought I would check.

Thanks!

[boom3]

Any thoughts on this? I'm going to install it this weekend.

Thanks!

[mahlon_r]

You could but it isn't necessary. It will work either way.
Good Luck,
Mahlon
?The opinions and information provided in this and all of my posts are hopefully helpful to you. Please use the information provided responsibly and at your own risk."

[gasman]

I would trim it to match the machining just because it is not backed up on the back side. Oil flow could cause that tab to erode and cause problems.