VansAirForceForums  
Home > VansAirForceForums

- POSTING RULES
- Donate yearly (please).
- Advertise in here!
- Today's Posts | Insert Pics


Go Back   VAF Forums > Main > RV General Discussion/News
Reload this Page Trutrak ADI Question
Register FAQ Members List Calendar Today's Posts

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 12-08-2010, 05:52 PM
bgaston bgaston is offline
 
Join Date: Aug 2008
Location: San Angelo, Texas
Posts: 71
Default Trutrak ADI Question
My ADI ( 360 hrs since new) has developed a new noise and some vibration of the display. It's very noticeable prior to engine start. Is this an early indication of a bigger issue and failure?
Reply With Quote
  #2  
Old 12-08-2010, 06:41 PM
Mike S's Avatar
Mike S Mike S is offline
Senior Curmudgeon
  
Join Date: Sep 2005
Location: Dayton Airpark, NV A34
Posts: 15,408
Default
I seem to remember this being an issue a couple years back, you might try searching the forums.

Also, if the voltage is down, the ADI will "tilt" over.

Keep us posted as to the outcome, please.

Good luck.
__________________
Mike Starkey
VAF 909

Rv-10, N210LM.

Flying as of 12/4/2010

Phase 1 done, 2/4/2011

Sold after 240+ wonderful hours of flight.

"Flying the airplane is more important than radioing your plight to a person on the ground incapable of understanding or doing anything about it."
Reply With Quote
  #3  
Old 12-08-2010, 07:30 PM
Noah's Avatar
Noah Noah is offline
 
Join Date: Jun 2007
Location: Rhode Island
Posts: 937
Default
Sounds like low voltage to me. Is your battery getting old? I have done some battery depletion testing and my ADI acts like this around 10-11 volts IIRC. When the engine starts and system voltage comes up due to the alternator the condition should disappear. What is the voltage at the ADI connector?
__________________
Highest Regards,

Noah F, RV-7A

All men dream, but not equally. Those who dream by night in the dusty recesses of their minds wake in the day to find that it was vanity: but the dreamers of the day are dangerous men? for they may act their dream with open eyes, to make it possible. -T.E. Lawrence
Reply With Quote
  #4  
Old 12-09-2010, 06:43 AM
bgaston bgaston is offline
 
Join Date: Aug 2008
Location: San Angelo, Texas
Posts: 71
Default ADI Issue
I just installed a new battery and have 13-14 v to the unit.
The noise sounds like a bearing going out. I'll take a closer look next time I run the engine.
Reply With Quote
  #5  
Old 12-09-2010, 07:38 AM
TrutrakTech TrutrakTech is offline
 
Join Date: Mar 2008
Location: Springdale, AR
Posts: 547
Default
It's more likely the servo driving the horizon mask. I replied to your email yesterday. Thanks!
__________________
Trutrak Tech Support
trutrakap.com
Reply With Quote
  #6  
Old 12-09-2010, 08:31 AM
bgaston bgaston is offline
 
Join Date: Aug 2008
Location: San Angelo, Texas
Posts: 71
Default ADI Issue
I haven't received reply from TruTrak regarding the problem with my ADI
Reply With Quote
  #7  
Old 12-09-2010, 08:41 AM
TrutrakTech TrutrakTech is offline
 
Join Date: Mar 2008
Location: Springdale, AR
Posts: 547
Default OOPS!
Sorry about that, it was sitting in my draft box. I apparently didn't hit the "send" button. NOW I've replied.
__________________
Trutrak Tech Support
trutrakap.com
Reply With Quote
  #8  
Old 12-09-2010, 09:24 AM
Bavafa Bavafa is offline
 
Join Date: Oct 2007
Location: Sacramento, CA
Posts: 3,344
Default
Lucas,
Last winter I reported issues with my ADI that it would sag and act lazy when it was cold and foggy day. "cold and foggy" was the only thing that I found as a common factor when it behaved that way. TT confirmed they had seen others reporting this but had no fix for it. Well it is winter time again and the other day my ADI was behaving the same. Is there any update or fix for it now?
__________________
Mehrdad
N825SM RV7A - IO360M1B - SOLD
N825MS RV14A - IO390 - Flying
Dues paid
Reply With Quote
  #9  
Old 12-10-2010, 10:52 AM
TrutrakTech TrutrakTech is offline
 
Join Date: Mar 2008
Location: Springdale, AR
Posts: 547
Default
Quote:
Originally Posted by Bavafa View Post
Lucas,
Last winter I reported issues with my ADI that it would sag and act lazy when it was cold and foggy day. "cold and foggy" was the only thing that I found as a common factor when it behaved that way. TT confirmed they had seen others reporting this but had no fix for it. Well it is winter time again and the other day my ADI was behaving the same. Is there any update or fix for it now?
Mehrdad, PM me or call with your serial number and I'll give you an RMA number to return it to us. We'll see what we can figure out.
__________________
Trutrak Tech Support
trutrakap.com
Reply With Quote
Reply

« Previous Thread | Next Thread »


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 10:49 PM.
Contact Us - VAFForums Home - Archive - Privacy Statement - Top

The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.