RA grip wiring help

[RV7Guy]

I brought my Ray Allen 207 stick grip to work with me to kill some time. This has the the 4 trim switches, the PTT switch and two additional push button switches.

The add'l push button switches are going to be used as AP disconnect and 430 comm flip/flop.

The instructions do not have any instructions for the additional switches. There are 3 poles on the switches. I did not bring my volt meter/continuity checker with me.

How do I wire these additional switches to accomplish my goal?

I'm using wiring style one on the ray allen website. www.rayallencompany.com

HELP!!!

[scard]

fyi, I set mine up exactly the same. I ended up having to disable the 430 flip/flop switch as it was never used for its intended purpose and was very often accidentally hit. Sorry, can't help you with the wiring specifics right now.

[DanH]

Darwin, with three solder tabs per switch you can bet they're NC, NO and common. The AP disconnect lead and the 430 flip-flop are each wired to a Normally Open tab. Wire both commons to ground.

[RV7Guy]

I wired it as you suggested. Will test tomorrow.

Thanks.