VMS1000C vs Lghtspeed Plasma II+
NEED HELP!!! After a few phone calls to Klause (Lightspeed) and the fine folks at JPI, I realized my Dual Lightspeed II's won't work with my VisionMicro engine monitor.  The E.I. output is 10 volts for the tach. The engine monitor requires 5 volts. Anyone have a fix for this problem? An alternative would be to use a tach generator off the tach drive. But, I'd rather not do that. I posted this question in the General Discussion forum, but didn't get many hits. Thought I'd try here as well. Thanks in advance.
__________________
__________________
Jerry Cummings
RV-9 (N791AC)
ECI XO-320-B1J1N4 (160hp), Catto 3-blade, Dynon EFIS, Vision Microsystems EMS, LightSpeed Electronic Ignition
Glendale, AZ
|
Linear Mode
