Duckworks nutplate template

wfinnell · #1 09-20-2009, 02:49 PM

Does anyone have a template for the Duckworks leading edge landing/taxi light kit that they can send me? I am looking for the template that shows where to install the nutplates on the wing?s leading edge ribs. I am working on my wings and I wanted to install the nutplates now if I could.

I sent an e-mail to Duckworks but they responded that they did not have the template in electronic format. I don?t remember the exact phrasing but they indicated that I should just go ahead and buy the lights now. I don?t want to buy now because I am not sure I want to go with the leading edge light, but I would like to install the nutplates while the wing is open.

I will gladly pay for postage and return the template.

Please send me an e-mail at: wfinnell@earthlink.net

Thank you,

Bill Finnell
RV-8 Wings
Tucson AZ

Rick_A · #2 09-20-2009, 05:48 PM

I just finished putting my lights in last week - it was the last big project on my to-do list. I've got the template cut out and ready to use.

Send me your address and I'll drop it in the mail tomorrow.

wfinnell · #3 09-20-2009, 09:28 PM

Rick,

I sent you my address in a PM.

Thanks again,

Bill Finnell
RV-8 Wings
Tucson

TCONROY · #4 02-26-2010, 08:28 AM

I'm in the same situation. I'd like to install the nutplates now, but not 100% sure I will go with the leading edge lights. Anyone have the template they could make a copy of for me?

Thanks!

WingsOnWheels · #5 02-26-2010, 08:58 AM

I also have the template and am done with my install. Shoot me a PM and I will mail it to you.

TCONROY · #6 05-11-2010, 07:44 AM

I received a PDF with the template, but it was copied and not to the correct scale. Anyone have an extra template for an RV-7A they could mail me?