Flap motor brush needed

[rvator51]

I have a bad brush in my flap motor. Does anyone know where you can get a replacement part versus paying $320 for a new flap motor?

[mannanj]

Originally Posted by rvator51

I have a bad brush in my flap motor. Does anyone know where you can get a replacement part versus paying $320 for a new flap motor?

http://www.clickautomation.com/produ...c=show&pid=343
would be a start. This page shows the whole motor which is only $87.00. Further research will probably turn up the brushes.

[Sunset9KU]

Check www.usherprecision.com they may have the ones you need.

[rich]

Here is a post from Jim Sharkey.
I bought a set just in case.

--------------------------------------------------------------------------------

Just to follow up - I received the new motor brush assembly from Motion Systems today a mere 24 hours after talking to them.

For $16 you can clean and refurbish one of the older actuators with a new brush assembly (p/n 79633-004) - and I'm sure that their service for complete motor replacements is just as good.

They are in New Jersey at
www.motionsystem.com
(732)222-1800

Jim Sharkey
RV6 - Heading to the airport for wing assembly!

From Rosie: I just bought a new set of brushes on 12 Oct 2011, no change in price, part & contact info all good ;-)

[rvator51]

Thanks Rich!