OD of strobe wire?

[Pmerems]

I am installing a bushing in the most aft bulkhead to pass the strobe wire to the rudder and I don't have my shielded strobe wire yet. There is limited room for the bushing so I need to install the smallest bushing I can.

Can someone measure their strobe wire and the post the OD.

Thanks,

Paul
RV-7A

[jsharkey]

0.23" dia wire - I used an SB-437-4 snap bushing in the wings and plan to use the same for tail.

Jim Sharkey
RV6 - Finishing Up

[Webb]

Nice fit through a 1/4" hole, a bit too tight to pull through a 15/64" hole.