Tip: Removing the handle from the stock fuel valve
To prevent breaking the internals on your stock fuel valve, do not pull up on the handle very hard as this can break the nylon inside where the pin goes thru it and the shaft.
Instead loosen the screw a few turns and then use your cleco pliers to pop the handle right off. Stick the forks of the pliers under the lever and the socket of the pliers over the screw and squeeze.
__________________
Brantel (Brian Chesteen), Check out myRV-10 builder's BLOG
RV-10, #41942, N?????, Project Sold
---------------------------------------------------------------------
RV-7/TU, #72823, N159SB
Lyc. O-360 carbed, HARTZELL BA CS Prop, Dual P-MAGs, Dual Garmin G3X Touch Track N159SB (KK4LIF) Like EAA Chapter 1494 on Facebook
Tip: Removing the handle from the stock fuel valve
Stick the forks of the pliers under the lever and the socket of the pliers over the screw and squeeze.
Linear Mode
