Spinner for FP Sensenich

[drmclaws]

I am changing from wood to new Sensenich FP prop on my 6A. I helped with the build but did not do the spinner for the wood prop. I was wondering if anyone has a suggestion for forming the area where the prop meets the spinner so the spinner can cont. aft of the prop onto the rear spinner plate. They show using a template on the plans for marking on the spinner but I didn't get one with the kit and if I have to make it was just wondering how you guys went about doing it. Appreciate any suggestions.

drmclaws

[647jc]

You can get a template off the internet via http://www.sensenich.com/new/rv6cut.htm