What spinner and backplate for a catto 3

[tonyjohnson]

For those with catto 3 blade props......what spinner and backplate did you use?

My kit came with the spinner and backplate for a CS prop. I ordered the s-605 backplate for a fixed pitch prop but found that it is too small for the spinner. So, it looks like I will have to get another spinner or use the CS spinner and backplate that I have.

I also notice that the prop extension, the standard black one from Vans, does not mate flush with the ring gear disk on the engine, there is about a .25 gap.

The holes in the backplates, both the fp and cs models, are two small to fit onto the prop extension.

Any advice from those who have gone before would be appreciated.

[hevansrv7a]

I got the backplate, the forward bulkhead and the spinner from Craig. He cuts them and marks a #1 on each for alignment. I also had the black 1/8 crush plate and the 4" extension already. I used the Saber extension and bolts.

[alpinelakespilot2000]

Originally Posted by tonyjohnson

For those with catto 3 blade props......what spinner and backplate did you use?
Any advice from those who have gone before would be appreciated.

Per Craig Catto, you need to order the parts from Van's for a fixed pitch wood prop (or have checked that box on your finish kit form).

[Mel]

I used all the standard parts from Van's. Everything worked great.

[tonyjohnson]

Mel,

Did you use the spinner and backplate for a wooden fixed pitch prop?

[Mel]

Yes!...........

[roadrunner20]

Originally Posted by tonyjohnson

Mel,

Did you use the spinner and backplate for a wooden fixed pitch prop?

Same here.