Labeling the fuse buss

Brambo · #1 12-07-2007, 07:28 PM

Not wanting to re-invent the wheel, I thought I'd check and see if anyone hase come up with a good way to label the fuse buss. There is a center strip about 3/4" wide but it still seems like a tight fit for labels. If anyone has picture of how they did it that would be great.

Bill Rambo
RV-7A

Guy Prevost · #2 12-08-2007, 07:48 AM

I haven't done it yet, but I'm planning on using the wires themselves. Take a look at Jim Daniel's site here: http://home.comcast.net/~jwdweb2/Wiring2/wiring2.html

kentb · #3 12-10-2007, 10:09 AM

I used small print on a label maker machine and put an abbreviated function and amp need for the fuse. This I placed on the small area of the fuse block.

Kent

AllanC · #4 12-10-2007, 12:04 PM

I used my label maker to put fuse numbers against each connection, then cross referenced the numbers to function and amperage on my wiring diagram. Each wire also has a label heat shrunk (clear) at the connector as well.

Allan