"Where were you when I laid the foundations of the earth?
Tell me, if you have understanding.
Who determined its measurements?
Surely you know!
Or who stretched the line upon it?
To what were its foundations fastened?
Or who laid its cornerstone,
When the morning stars sang together,
And all the sons of God shouted for joy?"
Job 38:4-7
Last edited by Scott Chastain : 08-27-2018 at 08:39 PM.
My MT spinner is fiberglass, not aluminum. Is yours? If so, I would not recommend countersinking it. It's not thick enough and then you'll have to use countersunk washers which actually are probably more noticeable than the pan head screws you're replacing.
__________________ Randy Pflanzer
Greenwood, IN www.pflanzer-aviation.com
Paid through 2043!
Lund fishing Boat, 2017, GONE FISHING
RV-12 - Completed 2014, Sold
427 Shelby Cobra - Completed 2012, Sold
F1 EVO - partially completed, Sold
F1 Rocket - Completed 2005, Sold
RV-7A - Partially completed, Sold
RV-6 - Completed 2000, Sold
Long-EZ - Completed 1987, Sold
The MT Propeller spinner is held on with #10 screws.
The spinner dome is made with Kevlar with an Epoxy resin.
There are no approved repairs for the MT Spinner Dome.
There are no approved modifications for the MT Spinner Dome, especially countersinking the spinner dome.
If you are interested in what I am testing on the MT Spinner Dome (with MT Propeller looking over my shoulder), give me a call at (805) 795-5377.
Jim Ayers
Less Drag Products, Inc.
MT Propeller Service
Custom Aircraft Propeller
MT Propeller Sales
MT Spinner Screws
Linear Mode
