Pretty sure this is;
TYP-----typical.
Used when a detail is repeated lots of times.
Example------if a part was to have a .040" radius on all edges, they would just say "edge radius .040" TYP"
__________________
Mike Starkey
VAF 909
Rv-10, N210LM.
Flying as of 12/4/2010 
Phase 1 done, 2/4/2011
Sold after 240+ wonderful hours of flight.
"Flying the airplane is more important than radioing your plight to a person on the ground incapable of understanding or doing anything about it."
Last edited by Mike S : 08-30-2019 at 09:44 AM.
|
Linear Mode
