Rear rudder pedals/Flyboys Accessories

Michael Henning · #1 10-10-2016, 02:51 PM

I installed the rear seat rudder pedals into my RV-4. It took less than 20 minutes from start to finish. My test "dummy" in the back was an A-10 Demo Pilot, he loved them! With the A-10 driver flying, there was very little interference between his feet and my hips. So two thumbs up for them. ��

sblack · #2 10-11-2016, 12:14 PM

do you have footwells? IF so, where did you put the pedals relative to the wells? I have those pedals and I have to do the same task. Any pics would be very helpful. Thanks

Michael Henning · #3 10-11-2016, 02:21 PM

Scott,
I don't have footwells. I mounted the the pedals as close to the rear of the main spar as I could, but still allowing full deflection. My install looked like the picture on Flyboy Accessories website, minus the footwells.

vfrazier · #4 10-12-2016, 10:17 AM

Michael,

Thanks for the kind words. I'm very pleased that you like the product.

Here is a link if anyone wants to see the product photos and description.

Interestingly, we have ONE set that is anodized RED. Normally, they are all clear anodized. If you'd like a RED set, please put a note in the comments section for Blake to see when you order.

Thanks!