Just make a small rectangular pin .090 X .032. Insert it in the slot above the on the terminal side, just above where the electrical pins insert.
Use the wire and move fore and aft until it releases. It will take longer to make the tool than to do it.
I have order a couple of terminals and will report if they fit this connector after evaluation.
__________________
Bill
RV-7
Lord Kelvin:
“I often say that when you can measure what you are speaking about,
and express it in numbers, you know something about it; but when you
cannot measure it, when you cannot express it in numbers, your knowledge
is of a meager and unsatisfactory kind.”
|
Power plane alt.
Linear Mode
