Dimple where it shouldn't be

[sblack]

I dimpked a part in the mistaken belief that the part to go on top was dimpled. Turns out the part on top was machine countersunk. Is there any problem squeezing the dimple flat i.e. metal fatigue etc?

[Palamedes]

I'm curious about this too.. I haven't done this (YET that I have found) but have come darn close to it a couple times..

[N546RV]

The consensus I've seen on here is that a dimple may be flattened or reversed once. I've done it on a couple occasions on my build so far.

[blueflyer]

Originally Posted by N546RV

The consensus I've seen on here is that a dimple may be flattened or reversed once. I've done it on a couple occasions on my build so far.

+1. I've flattened out an incorrect dimple or two.