washer part number?

Bevan · #1 05-31-2015, 10:58 PM

What is the part number for the small diameter washers one would use with a rod end bearing that is smaller OD than the standard 960 type washer?

This would be used to use as a spacer for a rod end bearing that is small enough in OD to not interfere with the bearing's operation?

Bevan

bruceh · #2 05-31-2015, 11:22 PM

Look on Van's order page for WASHER 5702-75-60.

It is called out on the wing attach & control system schematic page.

Bevan · #3 05-31-2015, 11:34 PM

Thanks Bruce. Would like to add some to a Spruce order but that part number is not valid at spruce. Surely Spruce must carry them (possibly under another number)

Bevan

RV6_flyer · #4 06-01-2015, 05:47 AM

Quote:

Originally Posted by Bevan

Thanks Bruce. Would like to add some to a Spruce order but that part number is not valid at spruce. Surely Spruce must carry them (possibly under another number)

Bevan

I believe that you will find it listed as NAS1149CO363R for the AN3 or 3/16" bolts at VAF advertiser Aircraft Spruce.

krw5927 · #5 06-01-2015, 06:50 AM

Quote:

Originally Posted by RV6_flyer

I believe that you will find it listed as NAS1149CO363R for the AN3 or 3/16" bolts at VAF advertiser Aircraft Spruce.

The AN960C washers have the same OD as the cad plated AN960 washer. I don't believe that's what the OP was looking for, and I think Vans is the only source (although you might find something in the aviation aisle of your local hardware store that would work equally well - just make sure it's stainless steel).

To the OP: If you only need one or two I could send them in an envelope.