Magnets
Quote:
Originally Posted by HBpilot
I haven't seen anybody use these, but they come very handy.
I am working on the HS and with that Van's SB for the cracks, there are a lot of pieces meeting together in the same place. So in order to know for sure that drilling a hole on one side will be ok on the other side, I found these tiny magnets (1/8 inch). I put them on, and now I am able to make sure I have all the required edge distances on both sides before drilling.
Found them on Amazon.
http://www.amazon.com/gp/product/B00...?ie=UTF8&psc=1
See a picture here :
https://www.dropbox.com/s/vnkzv87gbu...elete.JPG?dl=0 |
Good idea.
__________________
Larry Larson
Estes Park, CO
http://wirejockrv7a.blogspot.com
wirejock at yahoo dot com
Donated 12/03/2019, plus a little extra.
RV-7A #73391, N511RV reserved (2,000+ hours)
HS SB, empennage, tanks, wings, fuse, working finishing kit
Disclaimer
I cannot be, nor will I be, held responsible if you try to do the same things I do and it does not work and/or causes you loss, injury, or even death in the process.
|
Linear Mode
