This may be a silly question and I think I already know the answer but hey, I'm not an expert! The points where the rudder pedals and flap actuater go through the nylon type blocks... do these points ever require any lubericating and if so what kind?
Thanks in advance!
Nylon is "self lubricating". In fact, using any type of oil or grease product may actually degrade the nylon. If I recall correctly, water is typically used as a lubricant during the machining of nylon, rather than an oil based product.
Terry, CFI
RV9A N323TP
All men dream, but not equally. Those who dream by night in the dusty recesses of their minds wake in the day to find that it was vanity: but the dreamers of the day are dangerous men? for they may act their dream with open eyes, to make it possible. -T.E. Lawrence
Lubrication point question
Linear Mode
