Displaying timing advance and MAP on Skyview

[cbennet1]

Installing a LSE Plasma III and would like to use a spare input on the EMS to display timing advance.

In addition, rather than splitting the MAP line between the Skyview sensor and the LSE ECU, I assume I could use the LSE output for MAP as a replacement to the Skyview sensor.

Anyone done either of these? Did it work or were there issues?

Craig

[vlittle]

Originally Posted by cbennet1

Installing a LSE Plasma III and would like to use a spare input on the EMS to display timing advance.

In addition, rather than splitting the MAP line between the Skyview sensor and the LSE ECU, I assume I could use the LSE output for MAP as a replacement to the Skyview sensor.

Anyone done either of these? Did it work or were there issues?

Craig

I hve a voltage output on my Electroair ignition that provides a 10mV per degree signal representing timing. I created an input that displays this on my SkyView screen as 'DEGREE PSI'. This can be any of the non-temperature inputs. See Dynon Forum.