I'm wondering if anyone has already created a drawing of the Dynon / AFS COM-PANEL (Horizontal) radio that they would like to share. My CAD skills consist of cut/paste or slightly move things around. Getting rounded corners and overlapping rectangles drawn are outside of my abilities . I have the PDF dimension file from their website but that doesn't help me much getting it into my DXF file.
__________________
Ben Westfall
RV-10 (phase 1 flight testing)
Coeur d'Alene, ID
I see the link to the PDF dimensions are you saying there is a CAD file that is available on this page? I don't see a link to a CAD file and I don't have the necessary skills to draw the radio in TurboCAD based on the PDF dimensions. I do see the "Sand filled solid CAD model downloads" but I don't have any software that will open either an .IGS file or a .x_t file.
__________________
Ben Westfall
RV-10 (phase 1 flight testing)
Coeur d'Alene, ID
Last edited by bwestfall : 07-09-2014 at 12:57 PM.
Ben,
I just drew it in Autocad. PM me your email address and I will send you a CAD .dwg that you can use.
Quote:
Originally Posted by bwestfall
I see the link to the PDF dimensions are you saying there is a CAD file that is available on this page? I don't see a link to a CAD file and I don't have the necessary skills to draw the radio in TurboCAD based on the PDF dimensions. I do see the "Sand filled solid CAD model downloads" but I don't have any software that will open either an .IGS file or a .x_t file.
__________________
Carlos in Arizona
EAA Chapter 538 www.chapters.eaa.org/eaa538
Wittman Tailwind W8 N53CH (built & sold)
Pazmany PL-1 N2029 (bought & sold)
RV7 - N537TC (reserved & building)
Emp, Wings & Fuse done - working on FWF
"The air is an extremely dangerous, jealous and exacting mistress. Once under the spell most lovers are faithful to the end, which is not always old age." - Winston Churchill
Dynon/AFS com radio DXF file
. I have the PDF dimension file from their website but that doesn't help me much getting it into my DXF file.
Linear Mode
