Rudder cable dilemma

[BGordon]

Good evening everyone,
I am getting ready to put my rudder cables in and have an issue. Page 27A of the plans says to use a ms21919dg6 clamp to secure the cable where it leaves the fuselage. However the closest I can find in the hard ware is on page 3, bag 1974, ms21919wdg6. Is there a typo? Is this the same piece?
As always thanks,
Brandon

[vlittle]

Originally Posted by BGordon

Good evening everyone,
I am getting ready to put my rudder cables in and have an issue. Page 27A of the plans says to use a ms21919dg6 clamp to secure the cable where it leaves the fuselage. However the closest I can find in the hard ware is on page 3, bag 1974, ms21919wdg6. Is there a typo? Is this the same piece?
As always thanks,
Brandon

The wdg clamps are improved versions of the dg clamps. They have a rubber tab on them than better supports what you are clamping (especially wiring) and are virtually interchangeable.

Build on!

[BGordon]

Thank you very much

[RV7A Flyer]

As Vern said, the "W" indicates a "wedge" on the cushion. The "DG" indicates the cushion material.

Complete specs are here:

http://www.gen-aircraft-hardware.com...LoopClamps.pdf

Recommend getting a copy of the "blue book" from Genuine Aircraft Hardware, as it's a great reference book.