What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Fuel float arm dilemma

D

diamond

Well Known Member
I'm trying to figure out how the float arm wire inserts into the fuel sender so that the arm does not rotate. There is reference to a diagram DWG F-385B/C which must have the answer, but that diagram seems to be absent from my set of instructions. Does someone have that diagram they could maybe post a photo of it?
 
The end of the wire gets a 90 degree bend that insert into the sender. This prevent the float from rotating. Hope it makes sense
 
The end also calls for a 90 degree bend , 3/4 " long to prevent it from pulling out of the sender ..
 
The sender end has the 90 degree bend. The wire goes into two clips or holes. The very end goes into a hole and then after the bent , the wire pushes down into the clips. At least this is for the resistor type.
 
You must log in or register to reply here.
Back
Top