ariel_arielly
Active Member
Hii all.
I'm about to produce a new AUDIO PANEL to my -8A.
The audio panel is to be connected to the ICOM A200 Radio, actually, to its rear edge connector.
Since I don't have access to the panel right now, I would like to be adviced by who is familiar with this issue (the ICOM installation manual don't identify the P/N of the connector except it is "MOLEX").
My question is: "What is the MOLEX P/N of the connector, or, at least what is the spacing of the teeth on the PCB?"
Thank,
Ariel
I'm about to produce a new AUDIO PANEL to my -8A.
The audio panel is to be connected to the ICOM A200 Radio, actually, to its rear edge connector.
Since I don't have access to the panel right now, I would like to be adviced by who is familiar with this issue (the ICOM installation manual don't identify the P/N of the connector except it is "MOLEX").
My question is: "What is the MOLEX P/N of the connector, or, at least what is the spacing of the teeth on the PCB?"
Thank,
Ariel