rightrudder
Well Known Member
Hi guys,
A couple of quick questions. I bought the harness for my comm pre-made from ACS.
1) When mounting these, do you drill a hole for the size of the threads, or a larger hole for the boss at the base of the threads?
2) The photo shows how all the various washers were mounted on the jack. When installing, does it go nut/metal washer/fiber washer/panel/shoulder washer/jack? And does the shoulder portion fit up inside of the hole, or point toward the jack?
If it makes any difference, the harness is wired with PTT ground leads.
I was Googling this like mad, trying to find a simple drawing, but couldn't find a thing.
Thanks!
A couple of quick questions. I bought the harness for my comm pre-made from ACS.
1) When mounting these, do you drill a hole for the size of the threads, or a larger hole for the boss at the base of the threads?
2) The photo shows how all the various washers were mounted on the jack. When installing, does it go nut/metal washer/fiber washer/panel/shoulder washer/jack? And does the shoulder portion fit up inside of the hole, or point toward the jack?
If it makes any difference, the harness is wired with PTT ground leads.
I was Googling this like mad, trying to find a simple drawing, but couldn't find a thing.
Thanks!