Van's Air Force
Don't miss anything! Register now for full access to the definitive RV support community.
Page 10-20 Step 4: Rivet the F-01473A Angle Stiffeners...
- Thread starter md9680
- Start date
georgemohr
Well Known Member
Can't comment if this is ok or not, but I will say we had no trouble getting to these. Do you have a small tungsten bucking bar in your inventory? This guy is work 10x it's price. It has an angle on one side that allows you to get into small spots like this.
https://www.cleavelandtool.com/collections/riveting-and-bucking/products/tungsten-mini-bucking-bar
https://www.cleavelandtool.com/collections/riveting-and-bucking/products/tungsten-mini-bucking-bar
Thanks. That's what I intend to do.
Yes, and I even have that specific bar! Did you go in from the top or one of the access holes?
I just finished riveting them with no problems with my tungsten bar. Must've been all that Diet Mt. Dew last night that didn't allow me to see the way...?
Thanks to all who replied.
georgemohr
Well Known Member
Sometimes it goes like that. Ya just need to come back tomorrow, been there 
