G3x ammeter display backwards

I posted this directly to Steve (g3x)but realized he's pretty busy with sun and fun. Also, limited internet on site

As you can see from the pictures, the display is scaling backwards up to 0. Configuration is set to 0 to 55 amps. Switching the amp meter shunt leads makes no difference.
So basically I get no amp reading when the engine is on. All other gauge displays seem to be working fine.

Any suggestion?

Thanks,
Tom Hanaway

Not sure what you mean by "backwards." The number at the top reports total amps being drawn. The pointer moves up from the bottom. Here's mine:

Shunt

Swap the sender wires on the shunt .

Ah that may explain it. I'll check tomorrow. I guess I was expecting the scale during configuration to show the range numbers.
I.E., 0 at the bottom of scale and 55 at the top.
Tom H

maus92 said:

Not sure what you mean by "backwards." The number at the top reports total amps being drawn. The pointer moves up from the bottom. Here's mine:

Click to expand...