N42AH
Well Known Member
I have a flying RV-10 with an unsupported VP-200.
I have upgraded just upgraded from a 430W to an Avidyne IDF440.
The configuration in the VP-200 for the com is set as a 10 amp breaker and the nav side is set for a 3 amp breaker as was required by the 430W.
On the nav side the 3 amp is insufficient and needs to be either a 7.5 or 10 amp configuration.
The pin information is J4 P7
When I try to manually change the breaker value in the VP-200 configuration to a larger number/value it will not allow that and only allow me to go down in value. 3 amps down to 1 amp.
How do I allow or configure the pin to allow a value greater than 3 amps? Or can I?
Thanks for the VP education
I have upgraded just upgraded from a 430W to an Avidyne IDF440.
The configuration in the VP-200 for the com is set as a 10 amp breaker and the nav side is set for a 3 amp breaker as was required by the 430W.
On the nav side the 3 amp is insufficient and needs to be either a 7.5 or 10 amp configuration.
The pin information is J4 P7
When I try to manually change the breaker value in the VP-200 configuration to a larger number/value it will not allow that and only allow me to go down in value. 3 amps down to 1 amp.
How do I allow or configure the pin to allow a value greater than 3 amps? Or can I?
Thanks for the VP education