Page 14-3, I set the 2 rivets closest to the flanges on the W-1029C bracket crooked and ended up buggering up the holes while drilling them out. At this point I figure I have 3 options:
1. Upsize and rivet with 5-5 rivets
2. Upsize and install 3A bolts
3. Replace everything and try again
The bracket assembly itself is good it's the rib that's not.
Thoughts?
1. Upsize and rivet with 5-5 rivets
2. Upsize and install 3A bolts
3. Replace everything and try again
The bracket assembly itself is good it's the rib that's not.
Thoughts?