mill2978
Well Known Member
I'm assembling my gear towers and I can't get the nut onto two of the bolts, there is a conflict with the flange of the WD822 weldment. This is on both gear towers on the aft facing side.
The diagram shows the hardware should pass by the weldment, but I can't even start the threads on one with side with the washer on and the other I can get it on, but it'll cross thread if I force it.
It's the middle bolt on the lower left of the tower.
Is it ok to invert the hardware and put the nut on the outside? Will there be any clearance issues later if I do that?
Thanks
Aaron
The diagram shows the hardware should pass by the weldment, but I can't even start the threads on one with side with the washer on and the other I can get it on, but it'll cross thread if I force it.
It's the middle bolt on the lower left of the tower.
Is it ok to invert the hardware and put the nut on the outside? Will there be any clearance issues later if I do that?
Thanks
Aaron