Hi all,
I'm an RV-14 owner in Australia with a full Garmin panel - Twin G3X touch, GTN650, GMA245, GTR200, GTX23, GMC307, G5 etc.
I recently had a problem with the GMA245. Towards the end of an IFR flight and on the ground after I could not receive transmissions (either com). We did work out that I was transmitting successfully. The unit came good but this left me nervous and Garmin Australia agreed to replace it.
I assume that the new unit would be "plug & play" but when I installed it I had no intercom (I cannot even hear myself). I have tested transmit & receive and they are okay. I have updated the software and run through the error check for the GMA245 with no apparent issues.
Garmin Australia support and Stein don't seem to have any ideas so I thought I would put it out there and see if anything pops up.
Thanks
I'm an RV-14 owner in Australia with a full Garmin panel - Twin G3X touch, GTN650, GMA245, GTR200, GTX23, GMC307, G5 etc.
I recently had a problem with the GMA245. Towards the end of an IFR flight and on the ground after I could not receive transmissions (either com). We did work out that I was transmitting successfully. The unit came good but this left me nervous and Garmin Australia agreed to replace it.
I assume that the new unit would be "plug & play" but when I installed it I had no intercom (I cannot even hear myself). I have tested transmit & receive and they are okay. I have updated the software and run through the error check for the GMA245 with no apparent issues.
Garmin Australia support and Stein don't seem to have any ideas so I thought I would put it out there and see if anything pops up.
Thanks