VS/Rudder Storage

I've seen a few people store their VS/Rudder assemblies with what looks to be a 4x4 against a wall and the VS/Rudder hanging on either side. What are people using to "hang" them off the 4x4 - I assume something connected to the hinge points.

Open rafters, or ceiling?

Open rafters, just start putting finished parts up there.

I ran a sheetrock screw into a wall stud, left it out about a half inch, and then used safety wire to hang parts on the wall.

Cheap, and quick.

Storage

Mine lived in the attic until moved to the hanger, and had a brief stay in the guest bedroom during the initial fitting to the empennage. Didn't have the need to get crazy wiht the storage.

Eric Kallio