I am fitting in my Reflex Plus flap system and could use a bit of info, please.
- does the flap drive use the full travel or is it limited by the system to something less? If so, what is the travel of the drive shaft from reflex to fully down? I am trying to calculate the geometry for the position sensor.
- the Reflex instructions state that there is no need to program the fully up (I assume that means reflex) or fully down positions. Is this because the electronics sense when there is no further movement and therefore shut off the drive?
I have the electronics physically fitted and wired but I need this info to sort out the position sensor.
Finally, what do people use as flap settings? I was thinking reflex (cruise), zero (T/O and climb), 15 (Short T/O and downwind) and Full (Landing).
- does the flap drive use the full travel or is it limited by the system to something less? If so, what is the travel of the drive shaft from reflex to fully down? I am trying to calculate the geometry for the position sensor.
- the Reflex instructions state that there is no need to program the fully up (I assume that means reflex) or fully down positions. Is this because the electronics sense when there is no further movement and therefore shut off the drive?
I have the electronics physically fitted and wired but I need this info to sort out the position sensor.
Finally, what do people use as flap settings? I was thinking reflex (cruise), zero (T/O and climb), 15 (Short T/O and downwind) and Full (Landing).