VansAirForceForums  
Home > VansAirForceForums

-POSTING RULES
-Advertise in here!
- Today's Posts | Insert Pics

Keep VAF Going
Donate methods

Point your
camera app here
to donate fast.


Go Back   VAF Forums > Model Specific > RV-10
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 08-12-2008, 05:38 PM
Bart Bart is offline
 
Join Date: Jan 2008
Location: Pecan Plantation (0TX1)
Posts: 195
Default Rivet Head Door Pins Install Question

Has anyone installed the rivet-head aero after market door pins? My question is how the long door-tube gets modified for the pin. I did not get instructions and it appears that you need to cut the diagonal cut on the end and tap it for the new pin. The length seems about right if I did that way but before I cut I wanted to see what other folks have done.
Reply With Quote
  #2  
Old 08-12-2008, 06:28 PM
PJSeipel PJSeipel is offline
 
Join Date: Jan 2005
Location: Albany, GA for the moment
Posts: 294
Default

You'll have to get the pins short enough that when they're in the retracted position the door shuts without them hitting on the blocks. It'll probably be a little shorter than just the diagonal.

PJ Seipel
RV-10 #40032
Reply With Quote
  #3  
Old 08-12-2008, 06:50 PM
rv6ejguy's Avatar
rv6ejguy rv6ejguy is offline
 
Join Date: Mar 2005
Location: Calgary, Canada
Posts: 5,930
Default

I just did mine and you'll have to cut and try a few times to get them right. Start your first cut at the start of the angle. Be sure your linear gears are installed properly so you get full travel. Keep trimming the pushrods until they are just flush with the plastic blocks (retracted position).

I had to mill my aluminum pin blocks a bit as there was a bit of variation in recess depths fore and aft on my doors for the plastic guide blocks.

You'll have to modify the door seal setup to clear the aluminum blocks.

I feel a lot better about this setup over the Vans one but also added the safety latches to the main handles. I posted some photos last week on this easy mod.
__________________

Ross Farnham, Calgary, Alberta
Turbo Subaru EJ22, SDS EFI, Marcotte M-300, IVO, Shorai- RV6A C-GVZX flying from CYBW since 2003- 445.9 hrs. on the Hobbs,
RV10 95% built- Sold 2016
http://www.sdsefi.com/aircraft.html
https://www.youtube.com/channel/UCiy...g2GvQfelECCGoQ



Last edited by rv6ejguy : 08-13-2008 at 02:50 PM.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 06:44 AM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.