VansAirForceForums  
Home > VansAirForceForums

-POSTING RULES
-Advertise in here!
- Today's Posts | Insert Pics

Keep VAF Going
Donate methods

Point your
camera app here
to donate fast.


Go Back   VAF Forums > Model Specific > RV-3
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 01-03-2022, 10:41 AM
Chillibob Chillibob is offline
 
Join Date: Mar 2017
Location: Chillicothe, Ohio
Posts: 10
Default Installing and adjusting forward push-pull tube to control stick

Can any of you veteran RV-3 builders advise me on how to measure and adjust the length of the forward push-pull tube to make sure you have adequate travel when attached to the control stick (what is the neutral point on the control stick position - vertically level?). Also, when do you put it in permanently? I looks like it would be hard if not impossible to get in or out after the bottom seat skins are riveted on.
Reply With Quote
  #2  
Old 01-14-2022, 10:36 PM
RussellT RussellT is offline
 
Join Date: May 2016
Location: Albany Western Australia
Posts: 101
Default

I determined the length by setting fuselage level with stick and elevator bellcrank in a vertical position. Then with elevators in trail the rear pushrod length can be determined.
The forward pushrod can be removed rearwards but you must ensure the clearance holes in bulkheads F305, 306 and 307 are sized as necessary. A draw string tied on prior to removing the pushrod would probably assist in getting it back through if your seat pan is attached per plans.
I should say that I am not a "veteran" RV 3 builder but rather a first timer, and this is just how I did it...

Russell
__________________
RV 3B. Very slow build. Now onto final assembly...
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 01:10 AM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.