Originally Posted by Reaver
Does anyone know if the Dynon Skyview has the ability to monitor anything (other than tach) coming off of P-mags, similar to say an EI Commander? Is there any benefit to wiring up the TX/RX ports from the P-mags to the Dynon EMS-220 or similar?
I went an added a couple thermocouple probes to display the P-Mag case temps.
General Purpose Thermocouple
You may configure the SV-EMS-220 to monitor two J or K type thermocouples in addition to the twelve thermocouples available on the SV-EMS-220's D25 connector. Note that the SV-EMS-221 uses these four pins for Rotax 912 is communication, and, therefore, these pins are not available for thermocouple use on the SV-EMS-221. Dynon Avionics does not supply a specific general purpose thermocouple sensor for this purpose. However, our standard EGT and CHT sensors will work, as will any other J or K type thermocouple. They go into pins 27, 28, 36, and 37.
I programmed the EMS, and put a couple widgets on my screen. I didn’t get a chance to fly my plane yet and see what it displays in flight, but will later next week. I just stuck them on next to the temp sticker.
This is what I got. https://www.iothrifty.com/products/t...14364329574442