Has anyone used the standard ms20257 hinges on the cowl where plans call for 1/8 hinge? Looking at the vertical and bottom, it seems doable. Any thoughts would be appreciated and considered I have extra in the p4 width. Thank you
On the aft bottom sides (vertical hinges on lower cowl) I used heavy extruded hinges vs rolled soft alum. Not sure what newer kits supply stock (don't have my drawings handy). I recall the original hinge wore out in less than 1000 hours. The lower side takes a lot of load. Part numbers I don't recall with out research but it is a much larger pin than the Horz sides between top and bottom cowl haves.