Could be that I'm just trying to find stuff to do before my QB kits get here but I have a small concern on if I should rivet on the aft tailcone top skin now before taking the rudder, VS & HS off.
My plan was to wait till the very end post engine/avionics install and not inhibit my ability of getting back there, is that completely fine? Seems most builders rivet this on, and I would hate to torque something only to mount my bits and pieces later and have the plane torqued sideways... thoughts?
My plan was to wait till the very end post engine/avionics install and not inhibit my ability of getting back there, is that completely fine? Seems most builders rivet this on, and I would hate to torque something only to mount my bits and pieces later and have the plane torqued sideways... thoughts?