I'm installing my new Vans PR wheel pants onto my RV4. Installing as per the instructions with the 1" clearance on top of the tire etc. But considering that I'm running 380*150-5 tires and I'm not going to be able to get 5/8" to 3/4" clearance between the pants and the tire on the inside (brake rotor side)
If I keep trying to trim to get closer to the 5/8"+ the wheel pant will be cut so far up that there will be a lot of tire exposed and that the pants will be useless.
Options:
I can run them and see what happens.
Try and make new brackets to move the pants inward another 1/4" or so (not likely)
Or go back to the original 500*5 tires.
Just wondering what everyone else has seen and done?
Thanks
Tim
If I keep trying to trim to get closer to the 5/8"+ the wheel pant will be cut so far up that there will be a lot of tire exposed and that the pants will be useless.
Options:
I can run them and see what happens.
Try and make new brackets to move the pants inward another 1/4" or so (not likely)
Or go back to the original 500*5 tires.
Just wondering what everyone else has seen and done?
Thanks
Tim