Manifold transducer

Good afternoon everyone,
Working on my transducer manifold and can't seem to find the instructions. At least I thought I had them, maybe just my imagination. I do remember though, somewhere it showed the connections, and one looks like it came off at a 45 degree angle. Does anyone know the plans number for what I'm talking about, or am I making it up?

thanks
Brandon

Transducer Manifold

These are for the RV-8, injected and carbureted:

(Click to download)

View attachment OP34 RV8 IO-360.pdf

View attachment OP35 RV-8 320-360 Fwl Layout.pdf

thanks

I'm building a 7, but that looks very similar. Thank you!

B

Try OPs 27, 28, and 32.

Manifold

BGordon said:

I'm building a 7, but that looks very similar. Thank you!

B

Click to expand...

Also depends on the other stuff in the area.
Probably specific to my build (7A, IP-360-M1B) but just in case...
I had to fab a spacer to clear the diameter of the Kavlico transducers. I installed the transducers on the port side of the manifold. Plugs in the forward ports. Fittings on the starboard side.
I ended up cutting the third port off because it wasn't used and the space was useful. I have a Dynon MP transducer mounted elsewhere on the firewall.
Top port is a straight fitting to the oil pressure. Lower port is 45 degree to fuel pressure.